In short: If your PDF contains the cut line as a spot colour named “CutContour”, Snuglay’s “True Shape” mode nests the stickers by their real outline – rotated in 90° steps, with adjustable spacing for your cutter. Without a contour, Snuglay arranges them in a grid, like labels.
Why a grid wastes space with round stickers
A circle fills only about 79 % of its surrounding square (π/4). Lay round stickers out in a rectangular grid and over 21 % of every cell stays empty – corner after corner, across the whole sheet. Offset every other row by half a sticker and the rows slot into each other; for circles, coverage theoretically rises above 90 %. With hearts, stars, logos or animal shapes the difference is often bigger still, because slanted edges and notches leave room for the neighbour.
That’s what true-shape nesting does: it treats each sticker as the shape your cutter actually cuts – not as a rectangle.
What your PDF needs
- A cut contour as a spot colour on page 1. Snuglay recognises the usual names
CutContour,Dieline,CutLineandStickerCut(case doesn’t matter). - A closed line around the design – as a stroke, or as an outlined stroke, as Illustrator often exports it.
- Bleed outside the contour: let the artwork run 1–2 mm past the cut line so no white edge shows after cutting.
In Illustrator or Affinity, create a swatch as a spot colour named “CutContour” and give the cut line that colour as a stroke. In LaydoStudio it’s one click on the scissors icon – the contour travels along when you send the design to Snuglay.
How it works
- Open the PDF with the cut contour – Snuglay tells you whether it found the contour and then shows the “True Shape” mode.
- Pick the sheet: A4, A3, Letter or a custom size, such as your sticker paper.
- Set the spacing: the minimum gap between two contours, so the blade passes cleanly between stickers.
- Allow rotation (0°, 90°, 180°, 270°) if the stickers don’t need a fixed orientation.
- Let it calculate and save the PDF. The nesting runs entirely in your browser.
Before your first cutting job: open the exported PDF in your cutting software once and check that it picks up the contours as cut lines. Every cutter program names and expects cut colours a little differently.
Good to know
- True Shape works on fixed sheets. On rolls, Snuglay arranges pieces in a grid and works out the length: labels on a roll.
- Several designs: a multi-page PDF is cycled across the sheet in grid mode.
- Rectangular stickers or labels don’t need True Shape – use the ready-made label sheet layouts instead: print a PDF on a label sheet.